Service Manual

Replacing the status-light board
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your computer. After working inside your computer, follow the instructions in After
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Procedure
1. Place the status-light board into the slot on the palm rest and keyboard assembly.
2. Slide the status-light board cable into the connector on the system board and close the latch to secure the cable.
3. Adhere the foam that secures the status-light board to the palm rest and keyboard assembly.
Post-requisites
1. Replace the battery.
2. Replace the base cover.
16
32 Replacing the status-light board