Service Manual

Removing the display cable

NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow

the steps in Before working inside your computer. After working inside your computer, follow the instructions in After

working inside your computer. For more safety best practices, see the Regulatory Compliance home page at

www.dell.com/regulatory_compliance.

Prerequisites

1. Remove the base cover.

2. Remove the battery.

3. Remove the display assembly.

4. Follow the procedure from step 1 to step 2 in “Removing the display panel”.

5. Remove the camera.

Procedure

1. Peel off the tape on the sensor-board connector.

2. Open the latch and disconnect the sensor-board cable from the sensor board.

Figure 34. Removing the sensor-board cable

display panel 2. tape

3. latch 4. sensor-board cable

3. Peel off the tape on the display-cable connector.

4. Open the latch and disconnect the display cable from the display panel.

5. Note the display cable routing and remove the display cable from the routing guides on the display-panel assembly.

6. Peel off the tape that secures the display cable from the display-panel assembly.

7. Lift the display cable off the display-panel assembly.

Removing the display cable 61