Service Manual

Replacing the status-light
board
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your computer. After working inside your
computer, follow the instructions in After working inside your
computer. For more safety best practices, see the Regulatory
Compliance home page at www.dell.com/regulatory_compliance.
Procedure
1 Place the status-light board into the slot on the palm-rest assembly.
2 Adhere the foam that secures the status-light board to the palm-rest
assembly.
3 Slide the status-light board cable into the connector on the keyboard
daughter-board and close the latch to secure the cable.
4 Adhere the foam that secures the status-light board to the palm-rest
assembly.
5 Adhere the status-light board cable to the palm-rest assembly.
6 Route the speaker cable through the routing guides on the palm-rest
assembly and adhere the tape that secures the speaker cable to the
palm-rest assembly.
Post-requisites
1 Replace the battery.
2 Replace the base cover.
44