Service Manual

About this task

The figure indicates the location of the speakers and provides a visual representation of the installation procedure.

Steps

1. Using the alignment posts and rubber grommets, place the speakers in the slots on the palm-rest and keyboard assembly.

NOTE:

If the rubber grommets are pushed out of the speakers when the speakers were removed, push the grommets

back in place before replacing the speakers.

2. Route the speaker cable through the routing guides on the palm-rest and keyboard assembly.

3. Adhere the black tapes that secure the speaker cable to the touchpad bracket.

4. Connect the speaker cable to the system board.

Next steps

1. Install the 3-cell battery or 4-cell battery.

2. Install the base cover.

3. Follow the procedure in After working inside your computer.

Removing and installing components