Service Manual

CAUTION: Ensure that the battery cable is tucked between the battery and the system board when placing
the battery on the palm-rest and keyboard assembly to avoiding pinching the cable and damaging your
computer.
3. Place the battery on palm-rest and keyboard assembly.
4. Replace the four screws (M2x3) that secure the battery to the palm-rest and keyboard assembly.
5. Replace the screw (M1.6x4.5) that secures the battery to the palm-rest and keyboard assembly.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
Solid-state drive
Removing the M.2 2230 solid-state drive
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
About this task
NOTE: This procedure applies only to computers shipped with an M.2 2230 solid-state drive installed.
NOTE: The M.2 card installed on your computer will depend on the configuration ordered. Supported card configurations on
the M.2 card slot:
● M.2 2230 solid-state drive + 2230 mounting bracket
● M.2 2280 solid-state drive
● M.2 2280 Intel Optane H10
The following images indicate the location of the M.2 2230 solid-state drive and provides a visual representation of the removal
procedure.
Removing and installing components
21