Service Manual

Steps
1. Lift the Mylar that covers the system board.
2. Peel the thermal tape that covers the M.2230 solid-state drive and bracket.
3. Remove the screw (M2x2.5) that secures the M.2 2230 bracket to the system board.
4. Slide and lift the M.2 2230 bracket off the system board.
5. Slide and lift the M.2 2230 solid-state drive off the system board.
Installing the M.2 2230 solid-state drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
NOTE: This procedure applies if you are installing a M.2 2230 solid-state drive.
NOTE: Depending on the configuration ordered your computer may support the following M.2 cards in the M.2 card slot:
● M.2 2230 solid-state drive + 2230 mounting bracket
22 Removing and installing components