Service Manual

● M.2 2280 solid-state drive
● M.2 2280 Intel Optane H10
The following images indicate the location of the M.2 2230 solid-state drive and provides a visual representation of the
installation procedure.
Steps
1. Lift the Mylar off the system board.
2. Align the notch on the M.2 2230 solid-state drive with the tab on the M.2 card slot on the system board.
3. Slide the M.2 2230 solid-state drive into the M.2 card slot on the system board.
4. Place and slide the M.2 2230 bracket on the system board, aligning the notch on the M.2 2230 bracket to the groove on the
M.2 2230 solid-state drive.
5. Replace the screw (M2x2.5) that secures the M.2 2230 bracket to the system board.
6. Adhere the thermal tape over the M.2 2230 solid-state drive and bracket.
7. Place the Mylar over the M.2 2230 solid-state drive.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
Removing and installing components
23