Service Manual

Steps
1. Lift the Mylar that covers the system board.
2. Place the fan on the palm-rest and keyboard assembly.
3. Align the screw holes on the fan to the screw holes on the palm-rest and keyboard assembly.
4. Replace the two screws (M2x3) that secure the fan to the palm-rest and keyboard assembly.
5. Connect the fan cable to the connector on the system board.
6. Place the Mylar over the system board.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
Removing the fan (6-cell battery)
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
About this task
The following images indicate the location of the fan (6-cell battery) and provides a visual representation of the removal
procedure.
Removing and installing components
31