Service Manual

6. Close the right-display hinge and align the screw holes on the right-display hinge with the screw holes on the palm-rest and
keyboard assembly.
7. Replace the two screws (M2x4) that secure the right-display hinge to the palm-rest and keyboard assembly.
8. Place the Mylar that covers the system board.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
Coin-cell battery
Removing the coin-cell battery
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the 4-cell battery or the 6-cell battery, whichever applicable.
About this task
The following images indicate the location of the coin-cell battery and provides a visual representation of the removal procedure.
Steps
1. Disconnec the coin-cell battery cable from the system board.
2. Remove the coin-cell battery cable from the routing guide on the fan.
3. Using a plastic scribe, pry the coin-cell battery from the the palm-rest and keyboard assembly.
4. Lift the coin-cellbattery and its cable from the palm-rest and keyboard assembly
42
Removing and installing components