Service Manual

Installing the coin-cell battery
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following images indicate the location of the coin-cell battery and provides a visual representation of the installation
procedure.
Steps
1. Adhere the coin-cell battery to the palm-rest and keyboard assembly.
2. Route the coin-cell battery cable through the routing guide on the fan.
3. Connect the coin-cell battery cable to the connector on the system board.
Next steps
1. Install the 4-cell battery or the 6-cell battery, whichever applicable.
2. Install the base cover.
3. Follow the procedure in After working inside your computer.
Antenna module
Removing the antenna module
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the 6-cell battery.
Removing and installing components
43