Service Manual

Steps

1. Align the notch on the memory module with the tab on the memory-module slot.

2. Slide the memory module firmly into the slot at an angle and press the memory module down until it clicks into place.

NOTE: If you do not hear the click, remove the memory module and reinstall it.

NOTE: Repeat step 1 and 2 if there are two memory modules.

Next steps

1. Install the system-board shield.

2. Install the stand.

3. Install the bottom cover.

4. Install the back cover.

5. Follow the procedure in After working inside your computer.

Heat sink

Removing the heat sink

Prerequisites

1. Follow the procedure in Before working inside your computer.

2. Remove the back cover.

3. Remove the bottom cover.

4. Remove the stand.

5. Remove the system-board shield.

About this task

The following image indicates the location of the heat sink and provides a visual representation of the removal procedure.

Removing and installing components