Service Manual

Steps
1. Align the screw holes on the speakers with the screw holes on the display-assembly base and route the cable through the
routing guides on display-assembly base.
2. Replace the eight screws (M3 4+7.1xZN) that secure the speakers to the display-assembly base.
3. Route the speaker cable through the routing guide on display-assembly base and connect the speaker cable to the system
board.
Next steps
1. Install the system-board shield.
2. Install the stand.
3. Install the bottom cover.
4. Install the back cover.
5. Follow the procedure in After working inside your computer.
Microphones
Removing the microphones
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the back cover.
3. Remove the bottom cover.
4. Remove the stand.
5. Remove the system-board shield.
6. Remove the speakers.
About this task
The following image indicates the location of the microphones and provides a visual representation of the removal procedure.
Removing and installing components
35