Service Manual

NOTE: Note the routing of the antenna cables, before removing the antenna cables form the routing guides. Also, note the

location of the antenna modules printed on the display-assembly base as ANT-B (black) and ANT-W (white).

Steps

1. Remove the antenna cables from the routing guides on the display-assembly base.

2. Remove the two screws (M2x2.5) that secure the antenna modules (2) to the base panel.

3. Carefully peel the copper foil that secures the antenna cables (2) to the base panel.

4. Lift the antenna modules off the base panel.

Installing the antennas

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following image indicates the location of the antennas and provides a visual representation of the installation procedure.

Removing and installing components