Specifications

System Board: Dell Inspiron 8200
1 outer corner of upper
connector
2 network cable
14. Remove the three M2.5 x 4-mm captive-washer screws from the system board.
15. Remove the M2.5 x 20-mm screw from the center of the LED board.
16. Lift the front of the system board and work it out of the back panel.
If necessary to help release the system board, pull outward on the top of the
plastic near the back left corner of the bottom case (see the small arrow at the far
left in the following figure).
file:///F|/Service%20Manuals/Dell/Inspiron/8200/sysboard.htm (4 of 5) [2/28/2004 7:40:57 AM]