Manual

Adding and Replacing Parts 77

NOTICE: If you need to install memory modules in two connectors, install a memory module in the

connector labeled “DIMMA” before you install a module in the connector labeled “DIMMB.” Insert

memory modules at a 45-degree angle to avoid damaging the connector.

NOTE: If the memory module is not installed properly, the computer may not boot properly. No error

message indicates this failure.

Ground yourself and install the new memory module:

Align the notch in the module edge connector with the tab in the connector slot.

Slide the module firmly into the slot at a 45-degree angle, and rotate the module down

until it clicks into place. If you do not feel the click, remove the module and reinstall it.

memory module

securing clips

(2 per connector)

notch

D5169bk1.book Page 77 Thursday, October 21, 2004 4:37 PM