Owner's Manual

Hard Drive | 23
4 Remove the screws that secure the hard-drive bracket to the hard drive.
5 Lift the hard drive off the hard-drive bracket.
Replacing the Hard Drive
Procedure
1 Remove the new hard drive from its packaging.
Save the original packaging for storing or shipping the hard drive.
2 Align the screw holes on the hard drive-bracket with the screw holes on the hard
drive.
3 Replace the screws that secure the hard-drive bracket to the
hard drive.
4 Place the hard-drive assembly on the computer base.
5 Using the pull-tab, slide the hard-drive assembly toward the front of the computer,
to connect the hard-drive assembly to the connector on the system board.
6 Replace the screws that secure the hard-drive assembly to the computer base.
1 screws (4) 2 hard drive
3 hard-drive bracket
1
2
3
book.book Page 23 Friday, September 7, 2012 10:14 AM