Service Manual
8. Replace the two rubber bumpers at the bottom of the display bezel on either side.
9. Replace the display assembly (see Followtheinstructionsin"BeforeYouBegin"onpage9.).
Replacing the Display Panel
1. Remove the display assembly (see Followtheinstructionsin"BeforeYouBegin"onpage9.).
2. Remove the display bezel (see Replacing the Display Bezel).
3. Remove the six M2.5 x 3-mm screws securing the display panel.
4. Disconnect the cables from the connectors on either side of the inverter board and the 2-in-1 camera and LVDS cable from the connector on the camera
board.
5. Remove the display panel.
1
M2.5 x 3-mm screws (6)
2
inverter board connectors (2)
3
connector on the camera board
NOTE: Note how the cables have been routed to the display panel.
1
2-in-1 camera and LVDS cable