Service Manual

Back to Contents Page
Replacing the Keyboard
Dell™Inspiron™1210ServiceManual
1. Follow the procedures in Before You Begin.
2. Remove the hinge cover. See Replacing the Hinge Cover.
3. Remove the two M2 x 4-mm screws at the top of the keyboard.
4. Carefully slide the keyboard out of the computer and turn it over as shown in the illustration. Do not pull hard on the keyboard.
5. Release the connector latch that secures the keyboard cable to the connector on the system board and remove the cable.
6. Lift the keyboard away from the system.
7. To replace the keyboard, slide the keyboard cable into the connector on the system board and pull down on the connector latch that secures the
keyboard cable to the system board.
8. Align the four tabs along the bottom of the keyboard and slide the keyboard under the palm rest.
9. Replace the two M2 x 4-mm screws at the top of the keyboard.
10. Replace the hinge cover. See Replacing the Hinge Cover.
11. Slide the battery into the battery bay, until it clicks in place and slide the battery-lock latch towards the lock position.
NOTICE: Be extremely careful when removing and handling the keyboard. Failure to do so could result in scratching the display panel.
1
M2 x 4-mm screws (2)
2
keyboard
3
keyboard tabs (4)
4
connector latch