Service Manual

Back to Contents Page
 Replacing the USB Board
Dell™Inspiron™1210ServiceManual


1. Follow the instructions in Before You Begin.

2. Remove the palm rest. See Replacing the Palm Rest.

3. Remove the M2.5x3-mm screw that secure the USB board to the base of the computer.

4. Lift the USB board up and out from the base of the computer.

5. To replace the USB board, align the holes on the USB board to the protrusions on the base of the computer.

6. Replace the USB M2.5x3-mm screw to secure the USB board to the base of the computer.

7. Replace the palm rest. See Replacing the Palm Rest.

8. Slide the battery into the battery bay, until it clicks in place and slide the battery-lock latch towards the lock position.
Back to Contents Page

CAUTION: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as a connector on the back of the computer).
1
USB board
2
M2.5x3-mm screw