Service Manual

Back to Contents Page
 Replacing the Camera
Dell™Inspiron™1210ServiceManual


1. Follow the instructions in Before You Begin.

2. Remove the display assembly. See Followtheinstructionsin"BeforeYouBegin"onpage9..

3. Remove the display bezel. See Replacing the Display Bezel.

4. Remove the display panel. See Replacing the Display Panel.

5. Remove the camera board out of the protrusions that secure it firmly to the display frame.

6. Disconnect the 2-in-1 camera and LVDS cable from its connector on the display frame.

7. Remove the camera board.

8. To replace the camera, connect 2-in-1 camera and LVDS cable to its connector.

9. Align the camera board with the protrusions on the display frame.

10. Press the board gently until it sits firmly in the display frame.

11. Replace the display panel. See Replacing the Display Panel.

12. Replace the display bezel. See Replacing the Display Bezel.

13. Replace the display assembly. See Followtheinstructionsin"BeforeYouBegin"onpage9..

14. Slide the battery into the battery bay, until it clicks into place.
Back to Contents Page

CAUTION: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as a connector on the back of the computer).
1
2-in1 camera and LVDS cable connector
2
camera board