Service Manual



Display Panel



1. Follow the instructions in "Preparing to Work Inside the Computer."
2. Remove the display.
3. Remove the display bezel.
4. Remove the M2 x 3-mm ground screw that attaches the display-panel ground wire to the back display cover.
5. Remove the eight M2 x 3-mm screws from each side of the display panel.
6. Lift the display panel out of the display cover.

1
M2.5 x 6-mm screws (6)
2
rubber display bumpers (6)
3
display bezel
4
M2.5 x 6-mm shoulder screws (2)
5
screw covers (2)
CAUTION: Before performing the following procedures, read the safety instructions in your Owner's Manual.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by touching an unpainted metal surface on the computer.
NOTICE: To avoid damaging the system board, you must remove the main battery before you begin working inside the computer.