Service Manual
Table Of Contents
- Precision 3660 Tower Service Manual
- Contents
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of Precision 3660 Tower
- Side cover
- Front bezel
- 3.5 in. hard-drive assembly
- Removing the 3.5-inch hard-disk drive assembly (Bay-1)
- Removing the 3.5-inch hard-disk drive assembly (Bay-2)
- Removing the 3.5-inch hard-disk drive bracket
- Installing the 3.5-inch hard-disk drive bracket
- Installing the 3.5-inch hard-disk drive assembly (Bay-2)
- Installing the 3.5-inch hard-disk drive assembly (Bay-1)
- Solid-state drive
- WLAN card
- WLAN antenna
- Coin-cell battery
- Memory module
- GPU end holder
- Expansion card
- Power-supply unit
- Processor fan and heat-sink assembly
- Liquid cooler
- Processor
- Chassis fan
- Power button
- Intrusion switch
- Intrusion speaker
- System board
- Software
- System setup
- Troubleshooting
- Getting help and contacting Dell
Steps
1. Locate the position of rubber grommets.
2. Gently pull the rubber grommets to release the fan from the fan cage.
3. Remove the fan from the fan cage.
Installing the front fan cage
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the chassis front fan cage and provide a visual representation of the installation
procedure.
Removing and installing components
55