Service Manual
Table Of Contents
- Precision 3571 Service Manual
- Contents
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of Latitude 5531
- SIM card
- Micro Secure Digital (SD) Card
- Base cover
- Wireless card
- Wireless Wide Area Network (WWAN) Card
- Solid-state drives
- Removing the 2230 solid-state drive—SSD1 slot
- Installing the 2230 solid-state drive—SSD1 slot
- Removing the 2280 solid-state drive—SSD1 slot
- Installing the 2280 solid-state drive—SSD1 slot
- Removing the 2230 solid-state drive—SSD2 slot
- Installing the 2230 solid-state drive—SSD2 slot
- Removing the 2280 solid-state drive—SSD2 slot
- Installing the 2280 solid-state drive—SSD2 slot
- Memory
- Dummy hard-drive filler
- Hard-drive assembly
- Hard drive
- Battery
- Battery cable
- Assembly inner frame
- LED board
- Heat sink
- Speakers
- System board
- Power button with fingerprint reader
- Smart card reader
- Coin-cell battery
- Keyboard assembly
- Keyboard bracket
- Display assembly
- Display bezel
- Display panel
- Camera
- eDP/display cable
- Sensor board
- Display hinges
- Display back cover
- Dummy SIM-card slot filler
- Palm-rest assembly
- Drivers and downloads
- BIOS setup
- Troubleshooting
- Handling swollen Lithium-ion batteries
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Built-in self-test (BIST)
- System-diagnostic lights
- Recovering the operating system
- Real-Time Clock (RTC Reset)
- Auto RTC reset
- Backup media and recovery options
- WiFi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell
The following image indicates the location of the 2280 solid-state drive and provides a visual representation of the removal
procedure.
Steps
1. Remove the single screw (M2x4) that secures the M.2 2280 solid-state drive to the system board .
2. Slide and remove the M.2 2280 solid-state drive from the solid-state drive slot on the system board.
Installing the 2280 solid-state drive—SSD1 slot
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
NOTE: Solid-state drives are fragile. Exercise care when handling the solid-state drive.
NOTE: Depending on the configuration ordered, your computer may support a 2280 solid-state drive, or a 2280 solid-state
drive in M.2 slot.
NOTE: This procedure applies only if you are installing a 2280 solid-state drive in M.2 slot.
The following images indicate the location of the 2280 solid-state drive that is installed in M.2 slot and provides a visual
representation of the installation procedure.
32
Removing and installing components