Service Manual
Table Of Contents
- Precision 3571 Service Manual
- Contents
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of Latitude 5531
- SIM card
- Micro Secure Digital (SD) Card
- Base cover
- Wireless card
- Wireless Wide Area Network (WWAN) Card
- Solid-state drives
- Removing the 2230 solid-state drive—SSD1 slot
- Installing the 2230 solid-state drive—SSD1 slot
- Removing the 2280 solid-state drive—SSD1 slot
- Installing the 2280 solid-state drive—SSD1 slot
- Removing the 2230 solid-state drive—SSD2 slot
- Installing the 2230 solid-state drive—SSD2 slot
- Removing the 2280 solid-state drive—SSD2 slot
- Installing the 2280 solid-state drive—SSD2 slot
- Memory
- Dummy hard-drive filler
- Hard-drive assembly
- Hard drive
- Battery
- Battery cable
- Assembly inner frame
- LED board
- Heat sink
- Speakers
- System board
- Power button with fingerprint reader
- Smart card reader
- Coin-cell battery
- Keyboard assembly
- Keyboard bracket
- Display assembly
- Display bezel
- Display panel
- Camera
- eDP/display cable
- Sensor board
- Display hinges
- Display back cover
- Dummy SIM-card slot filler
- Palm-rest assembly
- Drivers and downloads
- BIOS setup
- Troubleshooting
- Handling swollen Lithium-ion batteries
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Built-in self-test (BIST)
- System-diagnostic lights
- Recovering the operating system
- Real-Time Clock (RTC Reset)
- Auto RTC reset
- Backup media and recovery options
- WiFi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell
Steps
1. Align the screw holes on hard drive with the screw holes on the palm-rest and keyboard assembly.
2. Replace the four screws (M2x4) that secure the hard drive to the computer.
3. Connect the hard drive cable to the connector on the system board.
Next steps
1. Install the base cover.
2. Install the microSD card.
3. Install the SIM tray.
4. Follow the procedure in After working inside your computer.
Hard drive
Removing the hard-drive assembly
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the SIM card.
3. Remove the microSD card.
4. Remove the base cover.
5. Remove the hard drive.
About this task
The following images indicate the location of the hard drive and provide a visual representation of the removal procedure.
Removing and installing components
43