Owner's Manual

o VMware - ESX and ESXi servers 3.5 and later
 Fibre Channel Switches:
o Brocade, McData, and Blade switches except director class switches
o Cisco 9124
 Tape Libraries:
o PV136T
o PV132T
o TL2000
o TL4000
o ML6000
 Ethernet and FCoE Switches:
o Dell PowerConnect 5424/5448
o Dell PowerConnect 6224/6248
o Dell PowerConnect 7024/7048
o Dell PowerConnect M6220
o Dell PowerConnect 8024/8024F
o Dell PowerConnect M8024/M8024K
o Dell PowerConnect M6348
o Dell PowerConnect B-Series 8000
o Cisco 2960
o Cisco 4948
o Cisco 3750E/3750X
o Cisco CBS 3130
o Cisco CBS 3030
o Cisco Catalyst 3750E
o Cisco Nexus 5020
o Dell Force10 S50/S60/S2410/S4810
Before collecting data, make sure to perform the settings provided in Software Requirements section.
Installation
Lasso 4.1 - Installation
Prerequisites
 Make sure IP connectivity is available to all defined devices.
 .NET framework 2.0 and SP v1.0 or later.
NOTE : In the case of EqualLogic, MD series, and Compellent SAN, .Net framework 2.0 or later must be installed on
the remote Windows host to successfully collect data.
NOTE : In the case of EqualLogic, Compellent, and MD series SAN, the SANsurfer CLI (iSCSI) software must be
installed on the remote Windows, Linux, and VMware hosts to successfully collect iSCSI HBA information.
NOTE : In the case of Compellent SAN, the SANsurfer CLI (FC) must be installed on the remote Windows, Linux, and
VMware host to successfully collect Qlogic FC HBA collection.
NOTE : In the case of Compellent SAN, the HBAnyware CLI must be installed on the remote Windows, Linux, and
VMware host to successfully collect Emulex FC HBA collection.
 To collect from EMC, use a system that is not a Fibre Channel attached host.