Owner's Manual

 LASSO-385: Lasso is not validating for Normal user in ESX and ESXi hosts.
 LASSO-386: New switch type " Brocade Ethernet " should be added in Lasso to support B8000 fails in CLI mode.
 LASSO-387: For the CNA port 1/1, the Ethernet information is not shown in HTML report.
 LASSO-388: Customer Contact page can proceed without complete details if Secure Site configuration file is loaded
and Secure site in unchecked.
 LASSO-389: FC HBA information should not be displayed in Vmware hardware/software section of html in VMware
Host attached to EqualLogic.
 LASSO-390: Some of the Brocade CNA-DCB Attributes are not displaying the correct value in HTML report.
 LASSO-391: Adapter Name and Vmknic bindings are displayed incorrectly in VMware hardware/software initiator
section in VMware ESX 4.1 host.
 LASSO-393: Lasso GUI should be improved based on feedback from Usability team.
 LASSO-394: The HITKIT tab should not be displayed under the VMware hosts in HTML report.
 LASSO-395: The option " Collect advance Logs " for VMware hosts should be available for EqualLogic and MD series
array type.
 LASSO-396: Show/Hide links for MAC Address attribute in VLan and Port Channel for PowerConnect Ethernet
switches are not working.
 LASSO-397: Lasso upload module does not display proper error message for an error code -26.
 LASSO-398: Lasso should parse DCB attributes for brocade CNA, when configured as FCoE. Report should also
display iSCSI priority table value under Networking/Multipathing section.
 LASSO-399: The Status for the dead paths under the Path Selection Policy for the ESX 4.0 host is not displayed in
HTML report.
 LASSO-400: The attribute " Priority Number " is spelt wrong for Cisco Ethernet switch under " Spanning Tree ".
 LASSO-401: Tokenization is not working when existing customer configuration file is loaded with Secured Site
option in CLI mode.
 LASSO-402: The HIT Kit for VMware attributes under " Management and monitoring Software " are not tokenized.
 LASSO-403: XML and HTML format of collection should not be generated if the output filename contains dots
(special characters).
 LASSO-404: Tokenization fails for Lasso single device collection in CLI mode when -OF option is provided.
 LASSO-405: Collect “show switch stack-ports” command information for PowerConnect M8024, M8024-K & 8024F
type switches.
 LASSO-406: Collect and Parse additional attributes for BASP.
 LASSO-407: Lasso HTML report displays wrong HITKit version when upgraded from v3.5.1 to v4.0.0 on Windows host.
 LASSO-408: Collect and Parse GlenLivet attribute “ eqlVolBalConfigHotColdPageSwapEnabled ”.