User's Manual

Error Code Error Message
308 SP collection timed out.
Try the collection again. If the error persists, make
sure that you have the latest Navisphere CLI. To
verify this, run the installer. Also, try to collect the
SP Manually. Finally, make sure that the firewall is
not blocking Navisphere from retrieving the
collection. For more information, see Network
Ports.
309 Non-supported SP version found.
310 NaviSECCli.exe was not found.
The .exe should be in C:\Program Files\EMC
\Navisphere CLI by default. If it is not found in this
location, try to run the installer again.
311 No LUNs found on Storage Array.
Configure at least 1 LUN or Hot Spare. Else Dell
cannot parse the SPCollect.
312 Not a Valid SPA or SPB Identifier.
The IP address entered may not be the Storage
Processor A in an EMC array. Verify that the IP
address is SPA (and not SPB).
313 Export command is not supported.
314 Navisphere CLI command failed to determine
whether EMC Array is having Navisphere Express or
Navisphere Manager.
315 Upgrade of Celerra is in progress.
316 EMC Add-on upgrade is in progress. Unable to run
NaviCLI.exe.
397 One or more commands that were run as part of
device collection failed.
398 SPCollect could not be automated. However,
getall/getlog was collected. Wrangler can still
parse this data, but no Layered Application
information will be loaded. You may need to
manually connect to Navisphere Manager and
collect an SPCollect.
401
Unable to collect storage management
information on RAID controller module.
The storage management software in use is not
compatible with the firmware on the RAID
controller modules in the Storage Array.
102