User Manual

Installing the thunderbolt over Type-C USB bracket

1 Insert the thunderbolt over Type-C USB bracket into the slot on the tablet.

2 Replace the M2x2.0 (3) screws to secure the thunderbolt over Type-C USB bracket to the tablet.

3 Install the:

a battery

b display panel

c microSIM card and microSD card

4 Follow the procedure in After working inside your tablet.

System Board

Removing the system board

NOTE: Heat sink is not a separate service part but is included with the system board. Do not remove the heat sink from the

system board

1 Follow the procedure in Before working inside your tablet.

2 Remove the:

a microSIM card and microSD card

b display panel

c battery

d WLAN card

e SSD card

f WWAN card

g front camera

h rear camera

i coin cell battery

j thunderbolt over Type-C USB bracket

3 Disconnect the following cables from the system board:

a power button cable [1]

b USH board cable [2]

c audio board cable [3]

d docking board cable [4]

e USH board cable [5]

Removing and Installing components