User Manual

Installing 4-cell battery

1 Insert the battery into the slot on the computer.

2 Route the battery cable through the routing clip and connect the battery cable to the connector on the system board.

NOTE

: Route the battery cable, if the cable at the base of the battery is un routed.

3 Replace the two M2.0 x 5.0 screws to secure the battery to the computer.

4 Install the base cover

5 Follow the procedure in After working inside your computer.

PCIe Solid State Drive (SSD)

Removing PCIe SSD

1 Follow the procedure in Before working inside your computer.

2 Remove the :

a base cover

b battery

3 To remove the PCIe SSD:

a Loosen the M2.0x3.0 captive screw that secure the SSD bracket [1].

b Remove the SSD bracket [2].

NOTE

: Ensure to remove the SSD bracket, if the system is shipped with bracket.

c Remove the PCIe SSD from the connector on the system board [3].

Removing and installing components