Owners Manual

e Lift the power and volume control board away from the computer [5].

Installing the power and volume control board

1 Place the power and volume control board on the computer.

2 Tighten the screw to secure the power and volume control board to the computer.

3 Route the cables through the cable routing clips.

4 Connect the power and volume control board to the connector on the system board.

5 Affix the adhesive tape to secure it.

6 Install the:

a coin cell battery

b battery

c base cover

7 Follow the procedure in After working inside your computer.

Solid State Drive (SSD)

Removing the solid state drive (SSD) card

1 Follow the procedure in Before working inside your computer.

2 Remove the:

a base cover

Removing and installing components