Owners Manual

4. Install the:

a. system fan

b. base cover

c. battery

5. Follow the procedures in After Working Inside Your Computer.

Removing the Display Assembly

1. Follow the procedures in Before Working Inside Your Computer.

2. Remove the:

a. battery

b. base cover

3. Perform the following steps:

a. Disconnect the antenna cables from WLAN card. Un-route the antenna cables from the WLAN card.

b. Remove the screw that secures the bracket over the display cable and remove the bracket.

c. Disconnect the display cable from the system board.

4. Perform the following steps:

a. Disconnect the touch panel, network connector, and display cables.

b. Remove the screws that secure the display hinges to the palmrest assembly.

c. Lift the palmrest assembly away from the display assembly.

CAUTION: Lift the palmrest assembly slowly to avoid damaging the display assembly.