Owners Manual

Installing the touch pad assembly

About this task

NOTE: Ensure that the touch pad is aligned with the guides available on the palm-rest and keyboard assembly, and the

gap on either sides of the touch pad is equal.

Steps

1. Place the touch pad into the slot on the palmrest and keyboard assembly [1].

2. Replace the four (M2x2) screws that secure the touch pad to the palmrest and keyboard assembly [2].

3. Adhere the tape that secures the touch pad to the palmrest and keyboard assembly [1].

4. Slide the touch pad cable into its connector on the system board and close the latch to secure the cable [2].

Removing and installing components