Operation Manual

Installing the touchpad
1 Place the touchpad into the slot on the system and replace the four M2x2 screws to secure it to the system.
2 Ax the adhesive tape to secure the touchpad pane.
3 Connect the touchpad cable to the connector and ax the adhesive-backed cable to secure it to the touchpad.
4 Align and place touchpad bracket over the plastic hold down and replace the two M2x2 screws to secure it.
5 Ax the adhesive tape to secure the touchpad bracket
6 Install the:
a battery
b base cover
7 Follow the procedure in After working inside your computer.
Display assembly
Removing the display assembly
1 Follow the procedure in Before working inside your computer.
2 Remove the:
a base cover
b battery
c hard drive
d Removing the WLAN card
3 Remove the eDP cable from its connector on the system board [1] and unroute the cable from the routing channel on the system fan
[2].
4 Unroute the eDP cable from the routing channel on the system [3].
5 Peel the tape securing the WLAN cables [4] and unroute the cables from the routing channel.
40
Disassembly and reassembly