Owners Manual
Table Of Contents
- Latitude 3490 Owner’s Manual
- Contents
- Working on your computer
- Disassembly and reassembly
- Recommended tools
- Screw size list
- SIM tray – optional
- SD card
- Base Cover
- Battery
- WLAN Card
- WWAN card – optional
- VGA board
- Memory Module
- Power button board
- Heat sink
- System Fan
- M2. SATA Solid State Drive (SSD)
- Hard drive
- Input-Output board, SD card and coin cell battery holder
- Fingerprint reader – optional
- Coin cell battery
- Speakers
- Touchpad panel
- Display assembly
- System board
- DC-In Port
- Display hinge cover
- LCD Bezel
- Camera
- LCD Panel
- eDP and camera cable
- LCD Hinge
- Palmrest
- Technical specifications
- Processor
- Memory
- Storage specifications
- Audio specifications
- Video specifications
- Webcam specifications
- Wired communications
- Wireless communications
- Ports and Connectors
- Display specifications
- Keyboards Hot Key Definitions
- Touchpad
- Battery specifications
- Adapter options
- System dimensions
- Security options
- Operating conditions
- Technology and components
- System setup options
- BIOS overview
- Entering BIOS setup program
- Navigation keys
- One time boot menu
- System Setup overview
- Accessing System Setup
- General screen options
- System Configuration screen options
- Video screen options
- Security screen options
- Secure Boot screen options
- Intel Software Guard Extensions screen options
- Performance screen options
- Power management screen options
- POST behavior screen options
- Virtualization support screen options
- Wireless screen options
- Maintenance screen options
- System logs screen options
- SupportAssist system resolution
- Verifying system memory in system setup BIOS
- Updating the BIOS
- System and setup password
- Clearing CMOS settings
- Clearing BIOS (System Setup) and System passwords
- Software
- Troubleshooting
- Contacting Dell
Installing the Input-Output board, SD card and coin cell battery
holder
1. Place the Input-Output (I/O) board into its slot on the palmrest.
2. Replace the M2x3 screws to secure the I/O board to the palmrest.
3. Connect the I/O board cable to its connector on the system board.
4. Install the:
a. speaker
b. battery
c. base cover
5. Follow the procedure in After working inside your computer
Fingerprint reader – optional
Removing the fingerprint reader
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. base cover
b. battery
3. To remove the fingerprint reader:
32
Disassembly and reassembly