Owners Manual
NOTE: The color of your tablet and certain components may appear dierently than shown in this document.
To avoid damaging your tablet, perform the following steps before you begin working inside the tablet.
1 Ensure that your work surface is at and clean to prevent the tablet cover from being scratched.
2 Turn o your tablet.
3 If the tablet is connected to a docking device (docked) such as the optional docking station or keyboard dock, un-dock it.
4 Disconnect the power adapter from the tablet.
5 Press and hold the power button for a few seconds to remove the ea power from the system board.
CAUTION: To guard against electrical shock, always unplug your tablet from the electrical outlet.
CAUTION: Before touching anything inside your tablet, ground yourself by touching an unpainted metal surface, such as the
metal at the back of the tablet. While you work, periodically touch an unpainted metal surface to dissipate static electricity,
which could harm internal components.
6 Remove the storage SD card from the tablet.
Turning o your tablet — Windows 10
CAUTION: To avoid losing data, save and close all open les and exit all open programs before you turn o your computer .
1 Click or tap .
2 Click or tap and then click or tap Shut down.
NOTE
: Ensure that the computer and all attached devices are turned o. If your computer and attached devices did not
automatically turn o when you shut down your operating system, press and hold the power button for about 6 seconds to
turn them o.
After working inside your tablet
CAUTION
: Leaving stray or loose screws inside your tablet may severely damage your tablet.
1 Replace all screws and ensure that no stray screws remain inside your tablet.
2 Connect any external devices, peripherals, and cables that you removed before working on your tablet.
3 Replace any media card, SIM card, and any other parts that you removed before working on your tablet.
4 Connect your tablet and all attached devices to their electrical outlets.
5 Turn on your tablet.
micro SD - micro SIM card
uSIM cards can be installed only on tablets shipped with WWAN module.
1 Follow the procedure in Before working inside your tablet.
NOTE
: disconnect the power and drain ea power before preforming the steps
2 Lay the tablet on a plane and at surface, with the kickstand facing upward.
NOTE
: Pull the kickstand to open by 135° to access the micro SD and micro SIM card slot
CAUTION: Do not pull or slide more than 135° to avoid damage to the hinges.
3 Slide and lift the cover.
Using your tablet
15