Owners Manual

Installing system board

1 Align the system board with the screw holders on the tablet.

2 Tighten the M2.0 x 2.5 screws to secure the system board to the tablet.

NOTE

: Remember to align the Type-C port and tighten the two screws to secure the port to the system chassis.

3 Route the antenna cables through the routing clips and channels.

4 Connect the docking board cable, speaker cable and the USH board cable to the connectors on the system board.

5 Install the:

a heat sink

b rear facing camera

c front facing camera

NOTE

: Remove the IR camera if shipped and installed on the tablet (optional).

d system fan

e WLAN card

NOTE

: Remove the WWAN card installed on tablets shipped with WWAM module (optional).

f SSD card

g battery

h display panel

i uSIM/microSD

NOTE

: uSIM card is installed only on tablets shipping with WWAN module.

6 Follow the procedure in After working inside your tablet.

Coin cell battery

Using your tablet