Owners Manual

c Lift the display assembly away from the computer [2].

Installing the display assembly

1 Place the base of the computer on a at surface.

2 Install the display assembly by aligning it with the display hinge screw holders.

3 Replace the M2.5 x 4.0 screws to secure the display assembly.

4 Close the display assembly and ip the computer.

5 Connect the cables:

a G-sensor and eDP cable

b Place the eDP bracket on the eDP cable and replace the M 2 x 1.7L on the bracket.

c IR camera and touch screen cables

6 Route the antenna cables through the routing clips

7 Ax the tapes to secure the antenna cables to the system board.

8 Install the:

a WWAN card

b WLAN card

c battery

d base cover

e Micro SD

9 Follow the procedure in After working inside your computer.

Removing dummy SIM card tray

For models shipped with a WWAN card, the SIM card tray must rst be removed from the system before removing the system board. To

remove the SIM card tray from the system, follow the steps outlined in the disassembly section of the Field Service Manual. For models

Extracción e instalación de componentes