Owners Manual
Table Of Contents
- Latitude 5300 2-in-1 Service Manual
- Contents
- Working on your computer
- Technology and components
- Major components of your system
- Disassembly and reassembly
- Troubleshooting
- Getting help
Steps
1. Peel the adhesive tape and disconnect the cable from the connector on the system board [1].
2. Remove the single (M2x4) screw that secures the eDP cable bracket to the system board [2].
3. Lift the eDP cable bracket from the system board [3].
4. Disconnect and unroute the eDP cable [4].
5.
Open the display assembly to a 180-degree angle and flip over the system, and then place the system on a flat surface.
Disassembly and reassembly
81