Owners Manual
Table Of Contents
- Latitude 5300 Service Manual
- Contents
- Working on your computer
- Technology and components
- Major components of your system
- Disassembly and reassembly
- MicroSD card
- SIM card tray
- Base cover
- Battery
- WWAN card
- WLAN card
- Memory modules
- Solid-state drive
- Speakers
- System fan
- Heat sink
- DC-in port
- LED board
- Touchpad button board
- System board
- Coin-cell battery
- Display assembly
- Keyboard
- Keyboard bracket
- Smart card reader board
- Display bezel
- Hinge caps
- Display hinges
- Display panel
- Camera
- Display (eDP) cable
- Display back cover assembly
- Palmrest assembly
- Troubleshooting
- Getting help
Steps
1. Peel the adhesive tape and disconnect the cable from the connector on the system board [1].
2. Remove the single (M2x4) screw that secures the eDP cable bracket to the system board [2].
3. Lift the eDP cable bracket from the system board [3].
4. Disconnect and unroute the eDP cable [4].
5.
Open the display assembly to a 180-degree angle and flip over the system, and then place the system on a flat surface.
82
Disassembly and reassembly