Operation Manual

Removing the battery

NOTE: A 4-cell 68Whr battery has only 1 screw.

NOTE: A 3-cell 68Whr battery has only 1 screw

1 Follow the procedure in Before working inside your computer.

2 Remove the base cover.

3 To remove the battery:

a Disconnect the battery cable from the connector on the system board [1].

b Loosen the M2.5x5 captive screw (1) that secure the battery to the laptop [2].

c Lift the battery away from the laptop chassis [3].

Installing the battery

NOTE

: 68Whr battery can be used with either a M.2 or 7mm SATA drive.

1 Insert the battery into the slot on the laptop.

NOTE

: Route the battery cable below the battery routing channels to enable proper connection to the connector.

2 Connect the battery cable to the connector on the system board.

3 Tighten the M2.5x5 screw to secure the battery to the laptop.

4 Install the base cover.

5 Follow the procedure in After working inside your computer.

Removing and installing components