Operation Manual

Installing the keyboard
1 Hold the keyboard and route the keyboard cable and the keyboard backlight cables through the palmrest in the system.
2 Align the keyboard with the screw holders on the system.
3 Replace the M2*2 screws (6) to secure the keyboard to the system.
4 Turn the system over and connect the keyboard cable and the keyboard backlight cable to the connector in the system.
NOTE: When reinstalling the chassis frame ensure the keyboard cables are NOT under the lattice , but run through the
opening in the frame before connecting them to system board.
5 Install the:
a keyboard lattice
b battery
c base cover
6 Follow the procedure in After working inside your computer.
Installing the keyboard trim
1 Align the keyboard trim with the tabs on the computer and press the keyboard until the keyboard clicks into place.
2 Follow the procedure in After working inside your system.
Heat sink
Removing the heat sink
1 Follow the procedure in Before working inside your computer.
2 Remove the:
a base cover
b battery
3 To remove the heat sink - Non touch:
a Remove the M2x3 screws (4) that secures the heat sink to the system board [1].
NOTE
: Remove the screws that secure the heat sink .
b Lift the heat sink away from the system board [2].
NOTE
: On systems with one piece heat sink and fan assembly there may also be screws on the fan that has to be
removed before the entire assembly is removed.
Removing and installing components 27