Operation Manual

Installing the system fan

1 Place the system fan on the system board and align the system fan on the screw holders.

2 Tighten the M2x3 screws to secure the heat sink to the system board.

3 Connect the fan cable to the connector on the system board.

4 Install the:

a battery

b base cover

5 Follow the procedure in After working inside your computer.

Power connector port

Removing the power connector port

1 Follow the procedure in Before working inside your computer.

2 Remove the:

a base cover

b battery

3 To remove the power connector port:

a Disconnect the power connector port cable from the connector on the system board [1].

NOTE

: Use a plastic scribe to release the cable from the connector. Do not pull the cable as it may result in breakage.

b Remove the M2.0x3.0 screw to release the metal bracket that secures the power connector port [2].

c Remove the metal bracket that secures the power connector port [3].

d Lift the power connector port away from the laptop [4].

Removing and installing components