Owners Manual
Table Of Contents
- Latitude 5520 Service Manual
- Contents
- Working inside your computer
- Major components of your computer
- Removing and installing components
- Recommended tools
- Screw list
- Subscriber Identity Module (SIM) card
- Micro Secure Digital (SD) Card
- Base cover
- WLAN card
- WWAN card
- Solid-state drive
- Memory modules
- Battery
- Battery cable
- Assembly inner frame
- LED board
- System fan
- Heat sink
- Removing the heat sink (for computers shipped with integrated graphics card)
- Installing the heat sink (for computers shipped with integrated graphics card)
- Removing the heat sink (for computers shipped with discrete graphics card)
- Installing the heat sink (for computers shipped with discrete graphics card)
- Speakers
- System board
- Power-button board
- Smart card reader
- Keyboard assembly
- Keyboard bracket
- Display assembly
- Display bezel
- Display panel
- Camera/microphone module
- eDP/display cable
- Sensor board
- Display hinges
- Display back cover
- Dummy SIM-card slot filler
- Palm-rest assembly
- Software
- BIOS setup
- Troubleshooting
- Getting help and contacting Dell
Steps
NOTE:
When removing the WLAN card from the system, if the adhesive pad which helps secure the WLAN card in place is
removed from the system along with the WLAN card, adhere it back to the system.
1. Loosen the single captive screw that secures the WLAN card bracket to the WLAN card.
2. Slide and remove the WLAN card bracket off the WLAN card.
3. Disconnect the antenna cables from the WLAN card.
4. Slide and remove the WLAN card from the WLAN card slot.
Installing the WLAN card
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the WLAN card and provides a visual representation of the installation procedure.
26
Removing and installing components