Owners Manual
Table Of Contents
- Latitude 5520 Service Manual
- Contents
- Working inside your computer
- Major components of your computer
- Removing and installing components
- Recommended tools
- Screw list
- Subscriber Identity Module (SIM) card
- Micro Secure Digital (SD) Card
- Base cover
- WLAN card
- WWAN card
- Solid-state drive
- Memory modules
- Battery
- Battery cable
- Assembly inner frame
- LED board
- System fan
- Heat sink
- Removing the heat sink (for computers shipped with integrated graphics card)
- Installing the heat sink (for computers shipped with integrated graphics card)
- Removing the heat sink (for computers shipped with discrete graphics card)
- Installing the heat sink (for computers shipped with discrete graphics card)
- Speakers
- System board
- Power-button board
- Smart card reader
- Keyboard assembly
- Keyboard bracket
- Display assembly
- Display bezel
- Display panel
- Camera/microphone module
- eDP/display cable
- Sensor board
- Display hinges
- Display back cover
- Dummy SIM-card slot filler
- Palm-rest assembly
- Software
- BIOS setup
- Troubleshooting
- Getting help and contacting Dell
7. Remove the assembly Inner frame.
8. Remove the system fan.
9. Remove the heat sink.
10. Remove the battery.
11. Remove the system board.
12. Remove the smart card reader.
13. Remove the keyboard assembly.
14. Remove the display assembly.
About this task
NOTE: For models shipped with WLAN antennas only, the dummy SIM-card slot filler is a separate service part and is not
included with replacement palm rest. As a result, the dummy SIM-card slot filler must be removed and then reinstalled when
replacing the palm-rest assembly.
The following image indicates the dummy SIM-card slot filler and provides a visual representation of the dummy SIM-card slot
filler removal procedure.
Steps
1. Push the dummy SIM-card slot filler from the top side of the palm-rest assembly.
2. Gently lift the dummy SIM-card slot filler out of the palm-rest assembly.
Installing the dummy SIM-card slot filler
Prerequisites
If you are replacing a component, remove the necessary component before the installation procedure.
About this task
The following image indicates the location of the dummy SIM-card slot filler and provides a visual representation of the dummy
SIM-card slot filler installation procedure.
Removing and installing components
91