Owners Manual
Table Of Contents
- Latitude 5520 Service Manual
- Contents
- Working inside your computer
- Major components of your computer
- Removing and installing components
- Recommended tools
- Screw list
- Subscriber Identity Module (SIM) card
- Micro Secure Digital (SD) Card
- Base cover
- WLAN card
- WWAN card
- Solid-state drive
- Memory modules
- Battery
- Battery cable
- Assembly inner frame
- LED board
- System fan
- Heat sink
- Removing the heat sink (for computers shipped with integrated graphics card)
- Installing the heat sink (for computers shipped with integrated graphics card)
- Removing the heat sink (for computers shipped with discrete graphics card)
- Installing the heat sink (for computers shipped with discrete graphics card)
- Speakers
- System board
- Power-button board
- Smart card reader
- Keyboard assembly
- Keyboard bracket
- Display assembly
- Display bezel
- Display panel
- Camera/microphone module
- eDP/display cable
- Sensor board
- Display hinges
- Display back cover
- Dummy SIM-card slot filler
- Palm-rest assembly
- Software
- BIOS setup
- Troubleshooting
- Getting help and contacting Dell
4. Remove the base cover.
5. Remove the WLAN card.
6. Remove the WWAN card.
7. Remove the assembly Inner frame.
8. Remove the system fan.
9. Remove the heat sink.
10. Remove the battery.
11. Remove the system board.
12. Remove the smart card reader.
13. Remove the keyboard assembly.
14. Remove the display assembly.
15. Remove the dummy SIM-card slot filler (only for non-WWAN configuration).
NOTE: For models with smart card reader configuration, the smart card reader is preinstalled in the replacement palm-rest
assembly.
About this task
The following image indicates the palm-rest assembly and provides a visual representation of the removal procedure.
Steps
After performing the steps in the pre-requisites, we are left with the palm-rest assembly.
Installing the palm-rest assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the palm-rest assembly and provides a visual representation of the installation procedure.
Removing and installing components
93