Reference Guide

1 - 14 Barcode Scanner Configuration Guide
Visual Decode Indicator
This feature specifies how many times to blink the illumination to indicate a successful decode. This feature is
disabled by default (no blink).
To enable this feature, scan a Decode Blink bar code to specify the number of blinks. Next, scan the Decode
Blink Duration bar code, and then scan two numeric bar codes from Appendix B, Numeric Bar Codes that
correspond to the desired duration of decode blinks in 100 msec increments. Values can range from 00 to 99
(9.9 seconds). Changing the Decode Blink Duration also changes the values set for Timeout Between
Decodes, Different Symbols.
To return the duration to the value specified by Timeout Between Decodes, Different Symbols on page 1-17,
scan Set Decode Blink Duration to Timeout Between Decodes, Different Symbols.
Decode Blinks
SSI # F2h 5Bh
Parameter #859
*Disable Decode Blinks
(00h)
1 Decode Blink
(01h)
2 Decode Blinks
(02h)
3 Decode Blinks
(03h)