Reference Guide

2 - 2 Barcode Scanner Configuration Guide
2 – 2 Barcode Scanner Configuration Guide
Scanning Sequence Examples
In most cases scanning one bar code sets the parameter value. For example, to disable image capture
illumination, scan the Disable Image Capture Illumination bar code under Image Capture Illumination on
page 2-16. The barcode scanner issues a fast warble beep and the LED turns green, signifying a successful
parameter entry.
Other parameters require scanning several bar codes. See these parameter descriptions for this procedure.
Errors While Scanning
Unless otherwise specified, to correct an error during a scanning sequence, just re-scan the correct parameter.
Imaging Preferences Parameter Defaults
Table 1-1 lists the defaults for imaging preferences parameters. To change the default values, scan the
appropriate bar codes in this guide. These new values replace the standard default values in memory. To recall
the default parameter values, scan the Set Default Parameter on page 1-5.
Table 2-1 Imager Preferences Default Table
Parameter
SSI Number
1
Parameter
Number
2
Default
Page
Number
Imaging Options
Aim Brightness (SE4750)
F1h 9Ch
668
0
2-5
Aim Brightness (SE4710)
F1h 9Ch
668
2 (High)
2-6
Illumination Brightness
F1h 9Dh
669
10
2-7
Decoding Illumination
F0h 2Ah
298
Enable
2-8
Decode Aiming Pattern
F0h 32h
306
Enable
2-9
Image Capture Illumination
F0h 69h
361
Enable
2-10
Snapshot Aiming Pattern
F0h 2Ch
300
Enable
2-11
Image Cropping
F0h 2Dh
301
Disable
2-11
Crop to Pixel Addresses
F4h F0h 3Bh;
315
SE3300/SE4500:
2-12
F4h F0h 3Ch;
316
0 top, 0 left, 479 bottom, 751 right
F4h F0h 3Dh;
317
SE4710:
F4h F0h 3Eh
318
0 top, 0 left, 799 bottom, 1279
right
SE4750:
0 top, 0 left, 959 bottom, 1279
right
Image Resolution
F0h 2Eh
302
Full
2-14
Image Brightness (Target White)
F0h 86h
390
180
2-15
Image File Format Selection
F0h 30h
304
JPEG
2-16