Service Manual
Table Of Contents
- 1. Introduction
- 2. Feature
- 3. Setting up your Rugged Scanner with USB
- 4. Technical specifications
- 5. RCC User Guide for Rugged Scanner with USB
- Barcode Settings
- Download and install Dell Rugged Scanner with USB module driver
- Download and install Dell Rugged Scanner with USB module driver
- Set up Dell Rugged Scanner module with USB
- Configure Dell Rugged Scanner module with USB
- Use Dell Rugged Scanner with USB
- Supported Symbologies
- Supported Symbologies for External Scanners
- Troubleshooting the Barcode Scanner with USB
- 6. Contacting Dell
RCC User Guide│ 20
Steps
1. Download and install any external scanner such as 123Scan Utility.
2. Open the scanner and wait for the drivers to update.
3. After the drivers are updated, go to the Data view tab, and select the
required scanner.
The detailed information about the scanner is displayed.
4. To check if your scanner is working, click the Flash/Beep scanner.
You can hear a beep sound from the scanner.
5. Go to Rugged Control Center, and check for the barcode scanner in
the Settings section.