Owners Manual

About this task

The following image indicates the location of the M.2 2280 solid-state drive and provides a visual representation of the installation

procedure:

Steps

1. Align the notch on the solid-state drive with the tab on the solid-state drive slot.

2. Replace the screw (M2x3) that secures the solid-state drive module to the system board.

Next steps

1. Install the heat-sink.

2. Install the display assembly.

3. Install the batteries.

4. Follow the procedure in after working inside your tablet.

WLAN card

Removing the WLAN card

Prerequisites

1. Follow the procedure in before working inside your tablet.

2. Remove the batteries.

3. Remove the display assembly.

About this task

The figure indicates the location of the WLAN card and provides a visual representation of the removal procedure.

Removing and installing components