Owners Manual

2. Replace the six (M2x5) screws that secure the system board to the tablet chassis.

3. Affix the adhesive tape and replace the (M2x5) screw that secures it to the system board.

4. Affix the conductive cloth that secures the camera MIPI plate on the system board.

5. Replace the two (M2x3) screws that secure the camera MIPI plate on the system board.

6. Connect the OpExpansion module pogo connector cable to the connector on the system board.

7. Connect the rear camera flexible flat cable (FFC) to the connector on the system board.

8. Connect the power button cable to the connector on the system board.

9. Insert and slide the microSD cable and NFC cable under the grommet.

10. Place the bracket and replace the three (M2x5) screws and two (M1.6x5) screws that secure the system board to the tablet chassis.

11. Connect the power adapter cable and replace the (M2x5) screw that secures the system board to the tablet chassis.

12. Connect the following cables to their connector on the system board (L-R): microphone board, LTE main + p-sensor, mic, smartcard,

fingerprint reader, microSD card, NFC, mini serial, speaker, pogo connector, right battery, and left battery from the system board.

13. As illustrated, affix the adhesive tapes to the connectors on the system board.

14. Connect the GPS cable to the system board.

15. Connect the antenna cables to the system board.

16. Connect the radio antenna cables and coin-cell battery cable to the system board.

17. Connect the antenna cable to the system board.

Next steps

1. Install the WWAN.

2. Install the WLAN.

3. Install the solid-state drive.

4. Install the system fan.

5. Install the heat-sink.

6. Install the display assembly.

7. Install the batteries.

8. Follow the procedure in after working inside your tablet.

Rear Camera

Removing the rear camera

Prerequisites

1. Follow the procedure in before working inside your tablet.

2. Remove the batteries.

3. Remove the display assembly.

4. Remove the heat-sink.

5. Remove the system fan.

6. Remove the solid-state drive.

7. Remove the WLAN.

8. Remove the WWAN.

9. Remove the microphone.

10. Remove the front camera.

11. Remove the coin-cell battery.

12. Remove the system board.

About this task

The figure indicates the location of the rear camera and provides a visual representation of the removal procedure.

Removing and installing components